AGFA 5366/300, User Manual

Page: 77 / 148

Viewing the film count info
During printing, you can always view the number of films left in the trays by
entering the operator menu.
WARNING:
Do not open the input trays to view the number of loaded films
during printing, but follow the procedure below:
To view the number of loaded films in the trays, proceed as follows:
During a print job, the ‘print’ screen is displayed:
1. Press the Escape key to enter the operator menu.
The ‘Operator menu’ screen appears:
2. Press the Down key once, followed by the Confirm key to select ‘Film count
info’.
The following screen appears:
The progress bar indicates the evolutions of the film usage in an input tray.
The bar is divided into 10 parts, each part represents approximately 10%
of the total films of a film pack. The last part of the bar will disappear
when more than 80% of a film pack has been printed.
3. Press the Confirm key to return to the print screen.
Note : When a film job cannot be done because the tray to
which the job is assigned is empty, then the printer will
check if the films in the other tray can be used for this and
other print jobs in the print queue. The printer will skip the
print jobs that cannot be done and will resume them later.
Crystal Imager | Basic Operation (operator mode) | 77
3831B EN 20210601 1655