AGA Stretton, Installation And Operating Instructions Manual

Page: 6 / 16

1. Grate Support
2. Grate 3. Optional Ashlip
5. Fixed Baffle
6. Loose Baffle 4. Cast Iron Side Liners
7. Back Bricks
8. Side Bricks 9. Fire Fence
Fig.6
1. Grate Support
Tilt the grate support up on one side and pass it
carefully through the door opening, it should then
rest on three supports approx. 100mm from the floor
of the stove grate.
2. Grate
The grate simply lays into the grate support but care
needs to be taken that the riddling bar will rest in the
middle of the fork.
3. Fitting Optional Ashlip
The ashlip is only to be used when the stove is floor
mounted. The ashlip must be fully supported under-
neath by the hearth. The ashlip can be adhered to
the hearth using a suitable adhesive after the stove
has been fitted or alternatively it can be screw fixed
using two screws provided. (See Fig.7).
The ashlip is to be pushed into place and has two
lugs which align the ashlip from side to side between
the sides of the external casing.
5
Fig 7
4. Cast Iron Side Liners
To insert the side liner bring the casting carefully
towards the opening, the bottom edge needs to go
towards the side it will fit to and the top edge goes to
the centre of the stove. With the casting tilted like
this, then the casting should pass through the open-
ing in the front.
When the casting is in the stove, manoeuvre it into
position by inserting the back edge first then the
front.
5. Fixed Baffle
The baffle fits to the roof of the stove using the two
M6 round head screws. With the screws in place, lift
the baffle into place with the main part of the baffle
to the rear of the stove, then slide the baffle so that
the screws are at the tip of the slots. Tighten the
screws to secure the baffle.
6. Loose Baffle
Hold the baffle by the ‘L’ shaped end with the fold
turned up. Manoeuvre it diagonally through the door
opening and then drop the rear edge to the rear of
the stove. Lift the ‘L’ shaped edge up over the ‘L’
shape on the side castings.
Move the baffle as far as possible to the front and
top. Then lift the back edge up and allow the baffle
to rest on the top rib on the back and in the ‘L’ shape
on the side castings.
Note: The secondary air holes
must be visible underneath the baffle.
7 & 8. Side & Back Bricks
Lay the side and back bricks in as shown.
Fig 8