General
z
Always switch OFF at the mains before cleaning.
z
Use as little water as possible.
z
Do not use CAUSTIC CLEANING SOLUTIONS
z
Do not use a steam cleaner to clean this cooker.
z
If milk or fruit juice or anything containing acid is spilt on the cooker, wipe it up
immediately.
z
Wipe up any spills as they occur and transfer pans to other burners to continue cooking.
z
Clean off any condensation streaks on the front plate around the oven doors or the vitreous
enamel maybe permanently discoloured.
z
TAKE CARE NOT TO DAMAGE THE OVEN THERMOSTAT PHIAL OR THE HOTPLATE
IGNITION ELECTRODES DURING CLEANING.
z
After cleaning, ensure all parts are thoroughly dry before replacing.
z
When re-fitting the burner caps and burner heads make sure that they are properly located.
z
THE FOLLOWING PARTS ARE NOT DISHWASHER SAFE:
Aluminum burner heads (LHR, CF, RHR, RHF).
Moving the Cooker
The cooker is fitted with mobility rollers, two at the rear and two at the front.
The 6-4 Series is designed to stand on a flat and level surface, however, any unevenness may
be overcome by adjusting the four levelling feet, one at each corner of the base plate. The
adjusting screws are accessed by removing left and right hand hotplate castings. To raise the
cooker turn screw clockwise, to lower turn screw counter-clockwise.
The rollers on the base of the cooker allow for positioning.
When the cooker is in the correct position the four levelling feet can be adjusted to level the
cooker.
THE FEET MUST BE LOWERED ENOUGH TO PREVENT THE COOKER ROLLING
OUT OF POSITION.
43
CLEANING & CARING FOR YOUR COOKER
Summary of Contents for SIX-FOUR Series
Page 19: ...Users Guide 19...
Page 22: ...22 Fig 10 DESN 512646 A...
