FM900 Built In Extractor
Installation, Operating & Maintenance Instructions
W0645 Aga Rangemaster FM900 (energy label version) O&M Jan 15.docx
P
age 3
AGA Rangemaster
Because the fixing holes are close to the edge of the soffit
cut-out it is recommended that pilot holes are drilled for the
fixing screws.
Secure the extractor in place using the screws supplied or
suitable alternatives for your panel and cut-out
arrangement.
One person should hold the unit in place whilst pilot holes
and screws are installed by an assistant – do not attempt
this on your own.
Note: Consider whether it is possible to build in provisions for
accessing the ducting with the unit in place - this may simplify
installation because ducting can be connected when the unit is
in position and will enable easier straightening of duct,
inspection and removal of the unit in the event of future
service.
Should you wish to remove the extractor then you will
require two people to safely undertake this work.
The removal process is the reverse of installation.
One person should hold the unit and prevent it falling
whilst an assistant removes the screws securing it in place.
Once the screws are removed both people can carefully
lower the appliance from the opening, taking care not to
damage the extractor or ducting in the process.
Tip: You may wish to positioned a platform on the hob
(such as a cardboard box) to place the extractor onto
because the connected ducting may not be long enough to
reach the work surface below.