22
Refit in the reverse order, making sure to push the rack down
onto the runner arms.
To Remove and Refit the Ladder Rack Supports
Lift the ladder support hooks out of the two locating holes in
the oven side (or divider) before lifting the support clear of
the bottom ladder restraint.
Refit by inserting the bottom of the ladder into the restraint
before fitting the hooks through the locating holes.
Before Using the Self-clean Function
Pre-clean any areas that are not reached by the self-clean
cycle, such as the outer edges of the oven door. Wipe up any
excess fat or liquids.
Before operating the self-clean cycle, use hot water and
detergent or a paste of water and baking soda to remove any
difficult spots. Rinse off all residue with vinegar water. This
will prevent this soil from being baked on by the high heat of
the self-cleaning cycle.
Self-clean Operation
Set the oven function control to self-clean
(Fig. 6.7)
. The
timer display will now show a ‘
P
’
(Fig. 6.8)
.
The Timer knob and Adjusting knob are shown in
Fig. 6.9
.
Turn the Timer knob to the [
] position
(Fig. 6.10)
to set the
default cleaning time (3 hours). To adjust the cleaning cycle
duration, rotate the adjusting knob; see
Table 6.1
.
Note that the maximum time for the self-cleaning operation
is 4 hours.
The cooling fan will switch to high speed and as soon as a
certain temperature is reached the oven door will lock as
indicated by the illuminated interlock neon
(Fig. 6.11)
.
Note:
Because of the high temperatures generated during
the self-cleaning, the door will remain locked for some
time after the cleaning cycle has finished. When the oven
temperature has fallen sufficiently the interlock neon will go
out and the door will unlock.
n
n
WARNING! The oven will still be hot!
When the door has unlocked turn the oven function control
back to OFF.
When the door has unlocked and the oven has cooled, use a
damp cloth the clean the debris and ash.
Fig. 6.7
Fig. 6.8
Fig. 6.10
Hours
Soiling
2 hours
Normal clean
3 hours
Heavy soiling
4 hours
Very heavy soiling
Table 6.1
A – Timer knob, B – Adjusting knob
A
B
Fig. 6.11
Fig. 6.9
