Handle Installation
1. Remove the handle, (2) screws, and 5/32” hex key wrench
from the bag shipped inside the cabinet.
2. Locate handle opposite the hinges and secure in place using
the (2) screws and the hex key wrench.
(See Figure 2).
Screws
Handle
Figure 2
Right hand hinged
door shown
HANDLE INSTALLATION
4
Door Alignment Procedure
The door should be parallel to the sides and top of the refrig
-
erator. If alignment is necessary the door may be adjusted
by loosening the 2 screws which secure the hinge adapter
brackets to the door and adjusting the door side to side. Use
a 5/32” hex key wrench for this procedure. (See Figure 3
below).
NOTE: For door closer to work properly it is necessary to main
-
tain a minimum space of 9/32” (7.1mm) between door and
cabinet flange as shown. This space can be adjusted by adjusting
the top and bottom hinge adapters.
NOTE
Figure 3
Hinge adapter screws loosen
these to adjust door, on the
top and bottom of the door
Top hinge pin re
-
move to remove
the door.
Door must be
parallel to top
and sides of
refrigerator
9/32”
(7.1mm)
