7
Setup
Please follow the steps one by one to setup your monitor.
1.
Split the dust-proof plastic sheet
Split the dust-proof plastic sheet from the screen surface of monitor.
2.
Connect the monitor to the computer (if you are using a video source, please skip
this step.)
There are two kinds of signal formats that are digital and analog. This monitor can
support both of them. Depending on the output signal of your computer, you may
need to use different signal cable and to connect into different port of the monitor.
Connecting to an IBM PC/AT or compatible computer by using the D-Sub
15-pin cableWith the computer being switched off, connect the analog
VGA signal cable to the “ANALOG” port at rear of the monitor and
computer.
Connecting to an IBM PC/AT or compatible computer by using the DVI
cableWith the computer being switched off, connect the digital DVI
signal cable to the “DIGITAL” port at rear of the monitor and computer.
Connecting to a Macintosh or compatible computer With the computer
being switched off, connect the analog VGA signal cable to the
“ANALOG” port at rear of the monitor and computer.
