68
ADJUSTING THE LCD DISPLAY
Item
Function
Operation
Range
Anti-Burn-in
• Mode
: Set the “Anti-Burn-in” mode.
Press the / button on the
control panel or the / button on
the remote control to select the
setting.
Off
A
B
C
• Interval (HOURS)
: Set the interval time
in hours between activating the Anti-
Burn-in
TM
function.
4
5
6
8
Alink
Enable or disable HDMI Consumer
Electronics Control control.
If the setting is set to
On
, you can control
the connected HDMI CEC-compatible
device on the same power on or power off
status.
Off
On
Advanced
Power
Management
Configure advanced power settings.
• Standby Mode
: Enables or disables
Standby mode. When the LCD display
turns into Standby mode, the screen
turns black and the LED indicator lights
amber.
Note:
The amount of time for the display
to enter Standby varies depending on the
Source Detect setting. If the Source Detect
is set to Auto, the display checks all input
source signals before entering Standby mode
if no signal is detected; this takes up more
time. If the Source Detect is set to Manual,
the display enters Standby mode right away.
Off
On
• Switch Power On State
: Choose the
display status used for the next time you
connect the power cord.
On
Standby
Last Status
• Switch Power On Delay Times
: Adjust
the power-on delaying time (in seconds)
allows a sequential powering-on for each
display by their ID number when multiple
displays are connected.
Press the / button on the
control panel or the / button on
the remote control to adjust the
value.
0 to 60
• Energy Saving
:
Choose Normal for PC wake up.
Press the / button on the
control panel or the / button on
the remote control to select the
setting.
Normal
Low Power
Standby
• LED Indicator
: Set the LCD monitor’s
LED indicator on or off.
Off
On
Auto
Brightness
Automatically adjust the screen brightness
according to the ambient light.
Off
On
