afx light 16-2081, User Manual

Page: 10 / 26

EN 10 © Copyright LOTRONIC 2022
• In the event of a serious operating problem, stop using the unit immediately. Never try to repair
the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The lenses, housing or ultraviolet filter must be replaced if they are visibly damaged.
• The light source of this device is not replaceable. If it is defective, the entire unit must be discard -
ed.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
FEATURES
• 1 x 100W LED
• 28 x 0.2W RGB SMD LEDs for the light ring
• DMX, master-slave, sound-controlled and auto operation
• 22/24/30 DMX channels
• "Totem" mode
• 1 colour wheel with 11 c open
• 1 static gobo wheel with 14 gobo's + open
• Gobo shake
• High precision optics with 2° projection angle
• Electric focus over 2-3m
• 16- & 24-facet prism with adjustable speed and direction
• Smooth, accurate 8/16 bit PAN/TILT with inversion
• Scan position memory with auto repositioning after an incident
• Rainbow effect with adjustable direction and speed
• Linear dimmer
• 25x/sec high speed LED shutter/strobe effect with variable speed
• Preset variable/random strobe and dimming pulse effect
• 1.8" TFT LCD display
• Fan cooling
• Management system with constant temperature readout
• Mounting via 2 omega clamps & safety eyelet
FUSE REPLACEMENT
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact cus
-
tomer support for further instructions. Continuing to use the unit may cause serious damage.