SN-AAT
1.
INSTALLATION
Input voltage: 7-16v.
If used compass, keep away from interference sources.
Close the compass, AAT support two installation directions, make sure you know which one you are
using.
WORK WITH SN_L FC
①
Make sure your OSD back-level is 125.
②
If OSD can not work normally please connect the video conditioner.
③
Check your firmware version is support aat; The latest firmware v6.0 can open the aat function
directly in the OSD setting menu.
2.
KEY OPERATION
UP
Switch menu; Select menu; Hold for 3 seconds to release, switch offline/tracking mode.
DOWN
Switch menu; Select menu.
ENTER
Enter menu; Hold for 3 seconds to release, compass calibration.
BACK
Back to previous.
3.
MAIN OSD
The main OSD has three display menus, including distance, speed, latitude and longitude, packet loss
rate and other information.
4.
OSD MENU OPERATION
Parameter menu: includes two pages, switch by
UP
and
DOWN
ITEM
DESCRIPTION
PORT
Port output mode
SERVO
Offline/Tracking
COMPASS
ON/OFF
DIR
AAT installation direction
CAL
check servo install error
VOL
Voltage bias
YWA/PITCH1/2
Accurately adjust the angle range of servo
BIAS1/2
Adjust the servo bias
CONNECT CAMERA CONDITIONER
CAMER
