Page 5
8. Connect Device Now.
Turn Printer ON:
1. Press Main Power Switch on Rear Panel.
2. Press Power Button on Control Panel.
Connect USB cable.
Do not click either
button.
Software will finish installing.
9. Finished software installation.
You can check “Set this printer as the default
printer” at this time. Click
“Finish”
.
10.
Close Installer.
11.
Restart computer to complete installation.
Step 5
Install Ink Tanks
Printer uses (1) Printhead and (5) Ink Tanks (
two Black,
one Cyan, one Magenta, and one Yellow
).
1. Look at the Control Panel
Touchscreen.
Ink Tank status
information appears in right
side of the Touchscreen. Note
that the
Ink
Tank
indicator
boxes are empty.
NOTE:
The question marks
indicate that no Ink Tanks are
detected by the Printer.
2. Open the Ink Tank Door
(
hinged at bottom
).
(
Disconnects Printer communication with Ink
Tanks and allows safe installation and
replacement
) Open Ink Tank Latches
[A]
.
3.
Remove new Ink Tank(s) from packaging.
4.
Insert Ink Tanks (
labels up
) into appropriate
color slots
[B]
. Close Ink Tank Latches.
INSTALLATION TIP: Make sure Ink Tanks
seat properly. Insert Ink Tank into
appropriate Ink Station, then pull Ink Tank
back about an inch and push forward firmly
to insure that Ink Nozzles penetrate seals on
Ink Tanks.
5. Close Ink Tank Door.
Ink colors
fill in as Ink Tanks are installed. If
ink colors do not fill in after a few
seconds, open Ink Tank Door
again and reinstall Ink Tank(s).
WARNING!
INK IN INK TANKS MAY BE HARMFUL IF
SWALLOWED. KEEP NEW AND USED INK
TANKS OUT OF REACH OF CHILDREN. DISCARD
EMPTY INK TANKS IMMEDIATELY.
