``
28
(Numbers refer to Figure 10)
Removing
and replacing
the battery
cover (2)
To remove the battery cover, unscrew the five screws (2.
3) holding it in
place, then lift it until it clears the seat-mounting post (4).
To replace the battery cover, re-install it over the seat-mounting post and
make sure it is seated properly, then secure it with the five screws.
Tyres
Correct tyre pressure is essential for steering and stability. Check the tyre
pressure every two weeks (25±2 psi).
Cleaning
Use only a damp cloth and mild detergent for cleaning. Never use a hose,
as this may severely damage the power and electronic components.
Replace
batteries
Note!
Batteries must be replaced by trained professionals only.
Warning!
Batteries contain high energy and can spark, resulting in a
possible fire hazard.
Warning!
Working with batteries can cause damage and Injury if not done
properly.
In this procedure, refer to Figure 11.
1. Remove the terminal insulating cap from one battery terminal.
2. Using an 8 mm key, unscrew the wiring from the terminal. Take care not
to let the key touch any other terminal or metal part, as this could cause
damage or injury.
3. Repeat steps 1 and 2 for all the other terminals.
4. Remove the old batteries and install the new ones.
5. Connect the wires of the new batteries as shown in Figure 11 (also
shown on the label located near the batteries).
6. Screw down the terminals securely, and replace the insulating caps.
Figure 11
