``
22
CHAPTER 6
– OPERATING INSTRUCTIONS
Figure 6
Figure 7
(Numbers refer to Figures 6 and 7)
Key switch
(1.17)
The main key switch is located on the tiller panel at the top of the
handlebar column (1).
The key switch has two positions:
OFF
: The
Breeze C
cannot be driven and the EMB is locked.
ON
: Power is supplied to the
Breeze C
and the EMB is released
automatically when the throttle control lever is squeezed.
To operate the
Breeze C
, insert the key in the key switch and turn it to
ON (clockwise). The switch will remain in this position and the green
LED (5.2) will be lit.
Note
: The key switch is used to operate the
Breeze C
, not for locking.
Automatic shut
off (optional)
This is an optional feature. When the key switch is ON, after a period of
time during which the throttle control lever is not used (the period is
programmed at the time the option is installed, and is usually 20
minutes), the control system will automatically shut off to save battery
charge. In the case of automatic shut-off, turn the key switch OFF and
then ON again.
Battery status
Indicator (5.1)
The battery status indicator is located on the tiller panel and shows you
the remaining capacity of the batteries. Like petrol gauges in cars, the
indicator is not absolutely accurate; it is merely a guide to help stop you
running out of fuel. The accuracy of the indicator also depends on the
type and age of the batteries.
When the indicator is in the yellow area, recharge batteries as soon as
possible.
When the indicator is in the red area, recharge immediately. When the
indicator is in the red, you can only drive a short distance (1-4 km on
level surface).
Fault indicator
(5.2)
The
ON
LED indicator is also uses as a fault indicator. When the LED
is flashing, it blinks the code of the fault. (See Maintenance Manual for
the codes).