2.Gimbal Outlook
1.Beginner Guide
3.Working Modes Instruction
1.Semi-following Mode：Camera Pitch and Roll Angles remain constant,
heading follows the handheld position.
2.All Following Mode：Camera Roll Angle remains constant,
Heading and Pitch follow the handheld position.
3.All Locking Mode : Heading, Pitch and Roll all locking.
4.Inverting Mode:Hold the gimbal reversely, the Heading and Pitch will
follow with the direction of hand-held rotation smoothly.
4.Standard and Optional Accessories
5.Video & Camera Charging
Interface Instruction
Insert the Batteries
Remove the power switch cap,
insert two batteries (model:
18350) into the handle.
Mode Switching
When the gimbal is working,
you can press the function
button to switch among the
three working modes.
(Please refer to the instructions
below for more details of working
modes.)
Pitch Axis Locking
The pitching axis can be adjusted under the pitch lock mode. Hand-pull the
camera till the desired angle and stay for 0.5 second until the current angle
is locked.
●
The gimbal must load the camera before starting.
●
The gimbal must keep upright before starting.
Proper Method for Using USB Data Cable
Attention: Please refer to the following method for
proper usage,otherwise it may cause damage to the
device itself and other equipment.
Battery Charging:
Plug the USB Mini terminal of the USB cable into the
interface of the charger, and plug the other USB
terminal into the power adapter. Or you can connect
to the European Standard connector if needed for
battery charging.
Camera power supply inlet
Connect the power supply cable，
for the Gopro power supply
Note ：the Power - line is additional configuration
Standard Installation Method
Install the Camera
Install the camera by the thumb
screw, and tighten the screw.
Power On
Keep the gimbal upright,then
press the power button to power
on the gimbal. Restart the gimbal
if the gimbal doesn
’
t work
properly.
Charger
For 16340/18350
Input: DC 5V Min 800mA
Output: DC 4.2V
Rechargeable
Battery
Extended
Thumb
Screw
Power Adapter
Style No.:18350
A
B
C
On-off Button
Function Button
E
D
Pitch Axis
Thumb Screw
Heading Axis
Function Interface
Front
Back
Inverting Mode
Mode Switch
Roll Axis
Video Input&
Camera
Charging
Interface
Power switch
Mode Switch Button
Press once to switch to the next mode to
identify current working mode through LED
status.
6.Mode Button Operation Function
Press once to complete a mode transfer, total 4 modes.
Mode 1-Semi-following Mode：Heading following ,Pitch&Roll keeping
balance automatically.
Mode 2, All Following Mode：Heading & Pitch following,Roll keeping
balance automatically (Default mode for power on)
Mode 3, All Locking Mode : Heading, Pitch and Roll all locking.
（ Pitch can be locked by hand-pull）
Mode 4, Inverting Mode（Invert the gimbal to enter into the Inverting
mode automatically）
Summary of Contents for VS-3SG
Page 1: ...297x210 3 80g 2016 09 27...
