![background image](http://html.mh-extra.com/html/afe-power/scorpion-79-21001l/scorpion-79-21001l_instruction-manual_2864093020.webp)
19
Note: Depending on your preferred look of the vehicle, you have the option to install the raw aluminum trim
pieces or leave them off.
Note: Please read the instruction below prior to installation.
30.
Begin by taping one (1) of the supplied raw aluminum trim pieces on the front of the aFe Scorpion grille
using two (2) pieces
of painter’s tape
(one on the top and one on the bottom). This will help hold the raw
aluminum trim piece while you install the light onto the aFe Scorpion grille.
31.
Install one (1) supplied
6” single row LED light through the front of the aFe Scorpion
grille (over the trim
ring if installed). While holding the
6” single row LED light
, install two (2) supplied #5 LED bar brackets
(bracket feet point away from each other) from the back of the aFe Scorpion grille and onto the studs on
the
6” single row LED
light. Install two (2) supplied 1/4" washers (black) and two (2) supplied 1/4" nylon
locknuts (black) on the lights. Do not tighten. From the front, install four (4) 10-32 x 5/8" screws through
the raw aluminum trim piece (if installed) and the aFe Scorpion grille. Turn the aFe Scorpion grille around
and make sure the 10-32 x 5/8" screws pass thru the #5 LED bar brackets. Use four (4) 10-32 flange nuts on
the 10-32 x 5/8" screws. Tighten all the hardware. Repeat Steps 30 and 31 for the three (3) remaining
supplied
6” single row LED light
s.
Summary of Contents for Scorpion 79-21001L
