Refer to Figure F for steps 16-17
Step 16: Install the (2) supplied T-bolt clamps J over the coupling at the turbo, and tighten. Also tighten
the T-bolt clamps on the filter and on the housing.
Step 17: Install the crank case breather hose into the rubber grommet on the Momentum HD intake
tube. Early models (built before 5/6/2007) 90-degree fitting can be reused. For later model
(built after 5/7/2007) production tubes, cut or pry the upper clamp off and use the
provided plastic 90-degree fitting H & mini clamp supplied G .
aFepower.com
Page 9
Figure F
INSTALL
J
G
H