![background image](http://html.mh-extra.com/html/afe-power/77-83028/77-83028_instruction-manual_2864077004.webp)
®
Refer to Figure A for Step 1.
Step 1: Before installing the aFe POWER Module you must place your vehicle’s ECU in sleep mode. In
order to place your vehicles ECU in sleep mode you will need to do the following:
-If the engine is cold, open the hood, close the doors, lock the car and wait 30 seconds
-If the engine is warm, open the hood, close the doors, lock the car and wait 20 minutes
-If the engine is warm and you can’t wait 20 minutes, disconnect the battery
Do NOT open the doors or start the vehicle when one of the sensor is disconnected.
This could create a check engine light.
REMOVAL
Page 4
Figure A