Afar AR24027, Operator'S Manual

Page: 58 / 100

AR24027 Operator’s Manual
4-17
>display-log region=all length=300 min-level=2 max-level=6
max-event
Sets the event severity level that should be saved or displayed. These two parameters are saved
as part of the configuration
save=0..7
Only events of the specified level or below will be saved in the event log.
print=0..7
Events of the specified level or below will be output to the console port as they occur.
Examples:
>max-event print=6
4.9 Miscellaneous commands
date
The AR24027 will set the internal radio date and time automatically by decoding Network Time
Protocol (NTP) packets in the Ethernet LAN. The “zone” parameter specified with the “date”
or “time” command will then be used to display the date/time in local time. The “zone” value
is saved as part of the radio configuration.
If NTP packets are not available, the user can initialize the radio date and time with either the
“date” or “time” commands. The parameters for both commands are identical, but the
parameter order is different. The date command can be entered as:
> date 16-may-2000 10:32:06
date=day-month-year
Sets the date used by the radio. The day / month / year parameter may be separated by any
valid separator (‘-‘ ‘/’ etc.)
time=hh:mm:ss
Sets the radio time in hours, minutes and seconds. Use colons to separate the three fields.
zone=zone-code or offset
Sets the time zone to be used by the radio to translate the NTP time to local time. It can be
specified by an offset from GMT (-0800 or +0200 for example), or as a “zone-code”. The valid
“zone-codes” and the respective offsets are shown below: