Installation, assembly & setting
Assembly Instructions EN
LM 12 I LM 16
Edition 11/2020
Rev. 2.5
33–52
Fig. 13
Assembly of proximity switch
For end position detection of the linear module pluggable proximity switches of
D 6.5 mm (Fig. 13, 1) or 8x8 mm (Fig. 13, 2) with holders (Fig. 13, 3) are used.
A LED on the proximity switch is used for function monitoring during end position
detection. If the LED does not change its switching state during end position
detection, the proximity switch is defective and must be replaced!
Depending on the type of control, the switching type PNP or NPN of the
proximity switches must be determined.
The 6.5 mm and 8x8 mm proximity switches may only be used with the AS
series stop screws!
Technical data for mounting the proximity switches:
- Operating voltage range 10-30 VDC
- Operating distance 1,5 mm
- Short circuit and reverse polarity protected