Aeware in.k450, Tech Book

Page: 14 / 28

13
in.k450 for in.xe spa systems functions and user instructions
Setting the time
Enter Programming mode by
holding Prog. key pressed down
for 3 sec. The display will show
the current time setting.
Setting the hour: Use Up or
Down arrows to change hour
setting (AM/PM) .
Setting the minutes: Press Prog .
key a second time.
Use Up or Down key to change
hour setting.
Setting fi lter cycle start time
To program the fi lter cycle, you
must enter these parameters:
the start time, duration and
frequency. During a fi lter
cycle, pumps run for one
minute to purge the plumbing,
then Pump 1 runs for the
programmed number of hours.
Press Prog . key a third time.
The display will show FSxx , with
"xx" representing the starting
hour.
Use Up or Down key to
change setting.
Setting fi lter cycle duration
Press Prog . key a fourth time.
The display will show Fdxx , with
"xx" representing the duration
in hours.
Use Up or Down key to
change setting.
Program key
Use Program key to display
time or enter Programming
menu by pressing and holding
key. In Programming mode,
the following parameters can
be set: time, fi lter cycle start
time, fi lter cycle duration,
fi lter cycle frequency, and
temperature unit.
Note: Light key is used as
Program key if this key is
not present.