2.8
If the measured resistance reading is
within limits, then it will display as
follows:
2.9
If the measured resistance reading
has gone beyond the limits, then it
will display the screen as follows:
Note: The above indicates that the ground
contact from the engine body to the battery
is bad. Check for rusted or corroded point
of contacts. If found, dismantle it for cleaning
or replace before fixing back. Repeat the test
again after fixing
2.10
If you did not follow the right
procedures during the testing, it will
display the results as follows:
2.11
To exit the program, pressing the
EXIT
key at any moment will exit and
return back to he main menu screen
3.
STARTER TEST
Note
:
Before performing this test, make sure
that the battery is fully charged and in good
condition.
3.1
With engine OFF, place
the vehicle
transmission in NEUTRAL for Manual
and PARK for Automatic then apply
the parking brake.
3.2
Connect the Analyser clips onto the
battery terminal posts and it will
power up and lights up the LCD
display screen as shown:
3.3
After you have made your choice,
selecting “New: Clear Memory” or
“Continue…Test” will proceed to the
main MENU, select “Starter Test” by
scrolling down:
3.4
Press
ENTER
key to continue and
the display will show as follows:
OK
The measured
Resistance value
is within limits
12.65V
Crank engine now
Until it starts.
Then press Enter
Voltage
RESULTS:
High Resistance!
Clean contacts
and check cables
RESULTS:
Not detected
. . .
Try again follow
right procedure
RESULTS:
New: Clear Memory
Last Test Result
Select Test
Continue Test . . .
Battery Test
Grounding Test
Alternator Test
Starter Test
