TRANSMITTER INSTALLATION WITH ROBÒ SELF CLEANING BASE
1 -
removing battery
(C)
inside transmitter
(T)
2 -
put the transmitter
inside the lodging
(G)
3 -
inserting support
(D)
and lock the transmitter .
4 -
fix support
(D)
at the base through the screw
(H)
.
Transmitter
(T)
turns on and off the central vacuum unit
when ROBÒ positions itself on self-cleaning base to start
the emptying phase of its dust container.
TRANSMITTER
SETTING BETWEEN TRANSMITTER AND RECEIVER
K
H
RECEIVER
ELECTRONIC
CARD
S
RECEIVER
Via Cerchia di S. Egidio, 760
47521 Cesena (FC) Italy
AERTECNICA S.P.A.
Tel. +39 0547 637311
Fax +39 0547 631388
www.aertecnica.com
T
A
R
T
T
G
H
D
C
Lithium battery 3V (CR2032)
1 -
check that the connection between the receiver
(R)
and the central vacuum unit is correct.
2 -
unscrew the aerial and open the receiver
(R)
3 -
remove the electronic card
(S).
4 -
press the button
(H)
, the LED will switch on
(K)
.
5 -
press the start button
(A)
of the transmitter
(T)
within 5 seconds
6 -
wait a few seconds for the memorisation of the new signal
7 -
close the receiver
(R)
and rescrew the aerial.
The setting has been completed. Whenever the transmitter button
(A)
is pressed, the
central vacuum unit will switch on.
The central vacuum unit and the wireless receiver must remain connected to the power supply
The wireless receiver is powered by 12 volts so no electrical hazard risk exists.
THE SETTING BETWEEN TRANSMITTER AND THE RECEIVER IS ALREADY SET BY THE MANUFACTURER
DELETING SAVED PROGRAMMES
1 -
disconnect the power line of the central power unit.
2 - unscrew the aerial and open the receiver
(R)
, remove the electronic card
(S)
and press the button
(H)
3 -
while still pressing the button
(H)
, reconnect the power to the unit
4 -
the LED
(K)
will switch on.
5 -
release the button
(H)
6 -
when the LED
(K)
switches off, the receiver memory has been deleted.
Once the receiver memory has been deleted, to reprogramming the transmitter follow
the previous procedure.
H
K
S
