76
9. Slide the right top wing panel onto the wing and
alignment tubes and slide wing panels together.
11. Secure outer cabanes with 8-32 x 10mm bolts,
flat washer and lock nut.
Note:
Outer struts have been pre-marked LB (left
bottom) and RB (right bottom) for easy refer-
ence.
12. Ensure lock nuts are tight and will not come lose
from engine vibration.
10. Using 8-32x15mm mounting bolts, install the
wing onto the center cabane as shown.
13. Slide the stab tubes in the fuse stab tube sleeves
(
short tube front, long tube rear
). Slide the
stabs on the stab tube and plug in the elevator
servo connectors. Slide the rubber backed wash-
ers on the stab mounting bolts and insert bolts
through the stab mounting tabs and into the fuse
blind nuts. Tighten snugly but do not over
tighten and crack the stab mounting tabs or the
fuse sides.
If you do not remove your stabs for transportation
purposes. We recommend you use (blue) Loctite to
help keep bolts from vibrating loose.
We recommend checking the stab
mounting bolts after each flying
session
Note:
If using the center cabane fairing refer to
page #79 for installation steps
