28
MAINTENANCE
Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap.
IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in.
If lines appear in the console display, see HOW TO
CHANGE CONSOLE SETTINGS on page 24 and
adjust the contrast level of the display.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 20.
HOW TO GREASE THE ROLLERS
See the EXPLODED DRAWING near the end of this
manual. If the Large Rollers (51) squeak when mov-
ing on the Tracks (11), fi rst clean the Tracks and the
Large Rollers with a lint-free cloth and rubbing alcohol.
Next, apply one packet (3 grams) of the included PTFE
grease to each Track. Use a lint-free cloth or your
fi ngers to spread the grease evenly along the Tracks.
Then, wipe off any excess grease. If the included
grease packets have been used or lost, use a high-
quality clear or white grease instead.
HOW TO CALIBRATE THE INCLINE SYSTEM
If the ramp is not functioning properly, the incline sys-
tem may need to be calibrated. To calibrate the incline
system, press and hold the small fan button for several
seconds until the test mode appears in the display.
Next, press the small fan button again. Then, press
the Quick Power Ramp increase or decrease button
to calibrate the incline system. The ramp will move
upward and downward as it calibrates.
When the ramp stops moving, the incline system is
calibrated. Then, press the small fan button repeatedly
to exit the calibration mode.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first
unplug the power cord.
Next, use
a standard
screwdriver
and carefully
pry the left
Disc Cover
(55) off the left
Disc (71).
Next, turn the left Crank Arm (20) until one of the
Magnets (43) on the Pulley (19) is aligned with the
Reed Switch (38). Then, loosen, but do not remove,
the two M4 x 16mm Screws (104), slide the Reed
Switch slightly closer to or away from the Magnet, and
retighten the Screws.
Then, plug in the power cord and turn the left crank
arm for a moment. Repeat the procedure above, if
necessary, until the console displays correct feedback.
Then, reattach the left disc.
55
71
43
38
19
104
20
MAINTENANCE AND TROUBLESHOOTING
Summary of Contents for edge 540
Page 4: ...4...
