Aerotech ABL1500-B, Hardware Manual, Page: 14 / 48

Overview ABL1500-B Hardware Manual
Model ABL1500-B-300 ABL1500-B-400 ABL1500-B-500
Travel 300 mm 400 mm 500 mm
Accuracy
(1)
E1
Calibrated ±0.7 µm ±0.8 µm ±0.8 µm
Standard ±12.0 µm ±16.0 µm ±20 µm
E3
Calibrated ±0.6 µm ±0.75 µm ±0.75 µm
Standard ±5.0 µm ±5.0 µm ±5.0 µm
Repeatability
(Bi-Directional)
(1)
E1 ±0.25 µm ±0.3 µm ±0.3 µm
E3 ±0.25 µm ±0.3 µm ±0.3 µm
Straightness
(1)
±0.75 µm ±1.5 µm ±2.0 µm
Flatness
(1)
±0.75 µm ±1.5 µm ±2.0 µm
Pitch ±3 arc sec ±4 arc sec ±5 arc sec
Roll ±3 arc sec ±4 arc sec ±5 arc sec
Yaw ±3 arc sec ±4 arc sec ±5 arc sec
Maximum Speed 2 m/s
Maximum Acceleration 2 g (No Load)
Maximum Force (Continuous) 93.6 N
Load Capacity
(2)
Horizontal 35 kg
Side 25 kg
Operating Pressure 80 psi ±5 psig
Air Consumption
(3)
24-30 slpm @ 551 kPa
Moving Mass (No Load) 5.9 kg
Stage Mass 29.0 kg 33.2 kg 37.1 kg
Material Aluminum
Mean Time Between Failure 30,000 Hours
(1) Certified with each stage.
(2) Axis orientation for on-axis loading is listed (refer to
Section 2.4. for offset loading behavior).
(3) Air supply must be clean, dry to 0° F dew point and filtered to 0.25 μm or better. Recommend nitrogen at 99.9% purity.
NOTES:
l
Specifications are for single-axis systems measured 25 mm above the tabletop; performance of multi-axis system is payload
and workpoint dependent. Consult the Aerotech factory for multi-axis or non-standard applications.
l
To protect air bearing against under-pressure, an in-line pressure switch tied to the motion controller/amplifier E-Stop is
recommended.
l
Maximum upper axis length is 100 mm when mounting the ABL1500-B in an XY configuration.
ABL1500-B Series Specifications (continued)
14 Chapter 1 www.aerotech.com