Installation and Configuration
Npaq® Hardware Manual
2.12. Miscellaneous I/O Connector (J12)
The Miscellaneous I/O Interface (J12) is a 15-pin ‘D’ style connector located on the Rear Panel Interface
board and is accessible at the rear of the Npaq chassis. This Interface provides 2 opto-isolated interrupt
inputs, the opto-isolated ESTOP input, +5 V, and the I/O Brake output if the I/O Brake option (see
) was ordered.
is the UINT specification table.
Table 2-47:
Miscellaneous I/O Connector Pinout (J12)
Pin #
Description
In/Out/Bi
Connector
1
Opto-Isolated User Int (Input 12+)
Input
2
Opto-Isolated User Interrupt - (Input 12-)
Input
3
+5 Volt (fused)
Output
4
Reserved
N/A
5
Reserved
N/A
6
Not Used
N/A
7
Opto-Isolated ESTOP + input, (5-24 volts)
Input
8
Opto-Isolated ESTOP - input, (5-24 volts)
Input
9
Opto-Isolated User Int (Input 13+)
Input
10
Opto-Isolated User Interrupt - (Input 13-)
Input
11
Common
N/A
12
Not Used
N/A
13
Not Used
N/A
14
I/O Brake + output (I/O Brake option only)
Output
15
I/O Brake - output (I/O Brake option only)
Output
Table 2-48:
Mating Connector Part Numbers for the Miscellaneous I/O Connector (J12)
Mating Connector
Aerotech P/N
Third Party P/N
15-Pin D-Connector
ECK00100
Amphenol DA15P064TXLF
Backshell
ECK01022
Amphenol 17E-1725-2
www.aerotech.com
Chapter 2
81
