7
4. FOX13-T SET-UP PROCEDURE
1. Lay the wing on the ground, with the bag zipper up and the nose of the wing pointing into the wind.
2. Undo zipper, undo Velcro ties and take out the control bar.
3. Lift and separate the control frame uprights.
Remove the quick pin from the corner bracket. Insert the corner bracket all the way into the control bar.
Install the quick pin bolt (from front to rear), securing the bracket to the control bar.
.
Figure 2
Figure 3
CAUTION
DO NOT FORCE THE FITTING INTO THE CONTROL BAR IF IT DOES NOT SLIDE IN FREELY AND
CHECK FOR DIRT OR DAMAGE TO THE FITTING OR THE INSIDE OF THE CONTROL BAR.
4. Flip the wing upright on the control bar. Try to set the control bar on level ground. Remove the wing
bag, protection pads and all the Velcro sail ties. Remove the battens set. Do not remove the leading
edge tip protection bags at this time.
5. By lifting up the nose batten, push the nose batten fully back into the sail so that the V-tip of the batten
rests on top of the keel tube (fig. 4).
Figure 4
Figure 5
6. Spread the wings almost all the way. Position the sweep back wires so, that they are on either side of
the kingpost mount (fig. 5).
7. Install the kingpost on to the kingpost mount (fig. 6), making sure the kingpost mount stays between
the sweep back wires. When installing the kingpost make sure the top wires and washout bridles are not
twisted or tangled (fig. 7).
