Aeros Combat-12.4-GT, Owner'S Service Manual

Page: 11 / 59

11
4.16. Undo the Velcro of the control frame apex protecting pads and insert the flaps of the control frame apex
protection pads inside the sail. Turn the hang point spreader bar perpendicular to the keel tube
(Fig. 17).
Close the central access zipper
(Fig. 18).
Figure 17 Figure 18
4.17. Install the tail on the glider:
- Take the tail out of the bag. Connect the outer tail sections with the centre tail section, installing the spar of the outer
tail first and then the pin at the trailing edge of the outer tail in to the corresponding holes in the centre tail
(Fig. 19).
Make sure that button springs of the outer tail sections spars are fully engage into the holes in the undersurface of
the center tail section
(Fig. 20).
Figure 19 Figure 20
Figure 21 Figure 22
- Slide the tail onto the keel tube until the button pins on the keel engages securely into the holes in the centre tail
section
(Fig. 21).