Dedusting unit ecomax 100
V02.00 Page 34 of 40
Chapter 7 Maintenance and
2
For your own safety, use
mouth/respiratory
protection and gloves.
Fold away the safety clamp
(1).
Pull out the blow-out
damper (2).
Pack it immediately in
dustproof packaging.
Fig. 16 Removing the blow-out damper
3
Hold the new blow-out
damper by the frame and
check it for visible damage.
Only use blow-out dampers
without visible damage.
Insert the blow-out damper
properly (1).
Ensure that the dust-air side is
at the top when inserting the
cover and thus points into the
fan chamber at the rear after
mounting the cover.
Fold the safety clamp in front
of the blow-out damper (2).
Insert the cover and screw it
on tightly.
Switch on the dedusting
device and at 100% power
check that the filter status
indicator is off.
Fig. 17 Inserting the blow-out damper
