7
2
1
3
3
1
5
6
4
8
5
17 mm
22 mm
1
1
1
1
8
3
7
1
3
3
1
2
3
4
5
Glue the deck beams (1) to the deck
reinforcement (2).
Glue the hull sides (3) to the
deck reinforcement.
Glue all the hull bottom beams (1) in
place as shown.
Check that all the parts are at right-
angles to each other before leaving the
glue to set hard.
Caution:
The slots for the servo plate are
located 22 mm below deck level.
Glue the corner fillets (5 + 6) in place.
Glue the transom (4) and the bow plate (8) to the corner
fillets (5 + 6) and the hull sides (3).
Sand the front edge of the hull bottom (7) to a chamfer so that it fits in the
angle between the bow plate (8) and the bottom beam (1) as shown. Starting
at the bow (8), glue the hull bottom (7) to the hull sides and the bottom
beams. Round off the edges of the hull sides with abrasive paper.
