Order No. 3048/00
This model is not a toy. If a young
person under 14 years is to build and
operate it, a responsible adult must
supervise the activity.
Introduction:
The model should be assembled following the sequence of the part numbers. These instructions are arranged by
stages in the correct order.
You may need to use a thin modelling knife to release the laser-cut parts from the sheets by cutting through on the
reverse side. The dark edges of the laser-cut parts should also be rubbed off using abrasive paper or a sanding pad
in order to obtain sound glued joints.
Check that all components fit accurately before reaching for the glue, and carry out any minor trimming required.
Allow all glued joints to dry out fully before starting the next stage of construction. We recommend a fast-setting
waterproof white glue for all joints.
We recommend that you apply a coat of sanding sealer (Order No. 7666/02) to all the wooden components and
sand the surfaces smooth before painting them.
We recommend our aero-pick
modelling pins, Order No. 7855/02, to
hold parts together when building the
model.
Tip: the laser-cut sheets include a large quantity of excess
material which is not required for building the model. It is a
good idea to place this material to one side, as it can be
used later to make handles, latches, fuel filler stubs and
similar, which help to give your model a livelier
appearance.
RC functions
Rudder
Forward / reverse
Optional
Lighting system
Specification
Length
455 mm
Beam
200 mm
Overall height
395 mm
RC
Min. two channels
Motor
Race 600 (7124/21)
Servo
Standard
Battery
6 V lead-acid, 7.2 V NiXX
or 7.4 V LiXX
