T-13
T-13
Remove wing panels from building boards, turn upside
down and cut off tabs with modeller´s knife or razor
saw.
33
Fit center wing sheeting T-13 to underside of
wing center and glue in place.
Drill a small hole in lower wing sheeting to
avoid a pressure build-up during covering and
on days with hot weather conditons.
34
T-13
Protect jigs for outer wing panels with tape at
wing spar and trailing edge positions (see
arrows on jig).
Use ribs to position lower spar T-14 and lower
trailing edge sheeting T-17, then glue in place
ribs T-3 to T-8.
Glue one rib T-3A to each rib T-3 at the wing
joint to provide for proper dihedral. Note that
bevelled side of ribs T-3A faces toward centre
wing.
31
T-17
T-14
T-3
T-8
T-3A
Glue in place upper wing spar T-15, leading edge T-16, upper trailing edge sheeting T-
17 and wing tips T-18.
Leave outer wing panels on building board to dry.
32
T-15
T-16
T-17
T-18
30.2
Fit centre wing sheeting T-13 in place in front of and
behind wing spar, then glue in place ans secure with tape.
Leave wing on building board until glue has completely
dried.
