Round off front of fuselage for a smooth transition to
R-36 and the spinner you will use on your model.
21
Use a razor saw to cut through R-28 and remove the canopy with the help of a sharp modeller´s knife. Cut through the upper part of canopy former
R-22 and glue R-44 in place.
Glue magnet support R-46 to R-47 and glue magnet R-43 in place with epoxy. Glue the complete magnet support into the canopy opening of the
fuselage.
Note:
Check orientation of magnets, before you glue, so that magnets attract each other!
22
R-47
R-46
R-43
R-44
Place horizontal stabilizer L-6 on the building board, glue both tips L-8 in
place and secure with pins.
Note that the wood grain in L-8 runs at an angle of 90° to the grain in the
stabilizer. This will prevent the stabilizer from warping.
24
Round off the front edges of fin and horizontal stabilizer with a grinding block. Glue fin in place
on horizontal stabilizer and make sure the fin is at an angle of 90° in relation to the stabilizer.
Check with a set square and secure with pins until dry.
25
Protect your building board with cling film and place fin L-1 and rudder L-2 on
the building board. Glue in place L-3 and L-4 and secure with pins.
Glue L-5 to the lower edge of the rudder and L-10 to the front of fin L-1.
23
L-1
L-2
L-3
L-4
L-5
L-10
L-6
L-7
L-8
Tailunit
