Blade 2
Building instructions - Blade 2
Page 4
Fuselage nose cone
Fit the nose cone (5) on the fuselage (1) from the front, and secure it with four self-tapping screws.
Elevons
The servos (Graupner DS 368 or comparable) for the elevons are installed in the wing panels. Solder
the servo leads to the cables already fitted in the fuselage, following the RC system instructions, and
fit suppressors in the leads.
Cut the slots for the horns (12) in the elevons, and glue the horns (12) in the slots. Connect the horns
(12) to the servos using the threaded pushrods (11) and clevises (10). Fit the servo well covers (7) and
tape them in place.
Elevon travels
When an aileron command is applied: 6 mm up, 6 mm down.
When an elevator command is applied: 10 mm up, 10 mm down.
The elevon travels are programmed using the servo travel adjustment facility on your transmitter.
Aileron 6 mm
Elevator 6 mm
Aileron 6 mm
Elevator 6 mm