7-4. Grasp the end of the fuel filter element, contained inside of the filter housing, and pull it out. Clean or replace the
element as needed.
7-5. Apply a small amount of grease to the o-ring on the inside edge of the filter element. Slide the element into the filter
housing until you feel it snap into place.
7-6. Apply a small amount of grease to the o-ring on the filter endcap. Position the endcap over the filter cover, aligning the
tabs and slots. Push the endcap into the housing, being careful not to nick or cut the o-ring.
7-7. Rotate the endcap clockwise until it stops. Insert and tighten the 8-32 screw and lock washer that were previously
removed.
7-8. Check the sump for any leakage from the filter housing area.
