Aeroflex 3500A, Maintenance Manual, Page: 62 / 169

2-38
S u b j e c t t o E x p o r t C o n t r o l , s e e C o v e r P a g e f o r d e t a i l s .
B. Generator Calibration (cont)
ANT CONNECTOR
10. Establish the following test setup:
Te st * Se t
ANT Pow er * Me ter * Sensor Pow e r * Me te r
Cha nnel * A
Ethe rne t
( * On ly * r eq u ir ed * f o r * AU T O * M o d e * )
11.
Press the F3 “CAL” Key.
12. Press the F1 “ANT” Key and follow the instructions on the screen to calibrate the UUT ANT
Port.
13. When the message “CALIBRATION COMPLETED” appears, press the F1 “Enter” Key to
display the Generator Calibration Screen.
SWR CONNECTOR
14. Establish the following test setup:
Te st * Se t
SWR Pow er * Me ter * Sensor Pow e r * Me te r
Cha nnel * A
Ethe rne t
( * On ly * r eq u ir ed * f o r * AU T O * M o d e * )
15.
Press the F3 “CAL” Key.
16. Press the F3 “SWR” Key and follow the instructions on the screen to calibrate the UUT
SWR Port.
17. When the message “CALIBRATION COMPLETED” appears, press the F5 “Enter” Key to
display the Generator Calibration Screen.
18. Cycle power on the Test Set.