© Copyright Aero-Spa®, LLC 2017 P/N102757 rev B
6
Install ballast tube.
1.
Remove screw from center section, slide ballast tube onto
bottom of diffuser section with a slight back and forth twisting
motion until the small hole on diffuser section is in the center of
the large hole in ballast tube. Insert screw and tighten until
screw head is flush.
Figure 3: Ballast Installation
2.
Connect the
free end of the 20’ ozone tube to the fitting
exiting the underside of the Aero-Pool unit. Secure with
provided cable tie.
3.
Lower the sintered diffuser into the pool
in an area that is 7’
deep or less and allow it to rest on the bottom.
4.
Locate the closest electrical outlet on the house or garage
that is at least 10
’ from the pool that can be used to supply
power to the equipment.
5.
Insert the electrical plug from the unit into a GFCI (Type 15-
5R) outlet. The equipment will begin to operate. You will hear a
faint hum from the generator and a steady bubble stream will
be emitted from the diffuser.
