CHOICE OF THE PLACE OF
21.1.
INSTALLATION
Before beginning installation agree on
the place of positioning with client and
pay attention to the following points:
The support surface must be able
−
to support the weight of the unit.
The selected place must have
−
enough space to permit laying of
the necessary pipes.
Remember that whilst operational
−
the heat pump can cause
vibrations; therefore anti-vibration
mounts (VT accessories) are
recommended. Fix them to the
holes on the base.
POSITIONING
21.2.
The unit is sent from the factory
protected by a cage of wood and
wrapped in plastic placed on a
pallet
Before handling the unit, verify the
lifting capacity of the machinery
used.
To prevent the VXT structure
being damaged by the belts place
protections between the latter and
the machine.
On removal of the packaging,
handling must be carried out by
qualified staff, which is suitably
equipped to handle the machine
“ON HORIZONTAL SURFACES”
Use lifting trucks or similar in the
−
most appropriate way and paying
attention to the distribution of unit
weights. (fig. 3).
−
Remove packaging carefully, pay-
ing attention not to damage the
various components of the appli-
ance
Loosen the safety blocks used
−
for transport with which the heat
pump is fixed onto the bed (once
the blocks are removed they are
no longer necessary).
ATTENTION:
THE WEIGHT OF THE UNIT CAN REACH
291 KG., LIFT IT IN COMPLIANCE
WITH THAT STATED BY THE RELATIVE
SAFETY STANDARDS
It is prohibited to stop under the
unit
−
It is mandatory to envision the
technical spaces necessary,
20.
SAFETY WARNINGS AND INSTALLATION
REGULATIONS
INSTALLATION
21.
Safety warnings
20.2.1.
i
The heat pump must be installed
by a qualified and suitably trained
technician, in compliance with the
national legislation in force in the
country of destination (Ministerial
Decree 329/2004).
A e r m e c
will not assume any responsibility for
damage due to failure to follow these
instructions.
i
Before starting any operation READ
THE INSTRUCTIONS CAREFULLY
AND PERFORM SAFETY CONTROLS
IN ORDER TO REDUCE ANY DANGER
TO A MINIMUM.
All staff involved must have thorough
knowledge of the operations and any
dangers that may arise at the time in
which the installation operations are
carried out.
Danger!
The refrigerant circuit is pressurised.
Moreover, very high temperatures can be
reached. The appliance may only be opened
by an after-sales service technician or by a
qualified technician. Interventions on the
cooling circuit may only be carried out by a
qualified refrigeration technician.
410A GAS
The unit comes supplied with a sufficient
quantity of 410A refrigerant fluid. This
is a chlorine-free refrigerant and does
not damage the ozone layer. R410A is
not flammable However, all maintenance
operations must be carried out exclusively
by a specialised technician using suitable
protective equipment
Danger of electric shock!
Before opening the unit, disconnect the
appliance completely from the mains
power supply.
Transport of the VXT
Fig.4.
Lifting
Fig.6.
SEE NOTE ABOVE
max
max
Removal of the safety blocks
Fig.5.
32
