AERMEC HRS 030, Installation, Use And Maintenance Manual

Page: 14 / 29

3.7 iany installation of the section with water coil HrS_CS
A plastic bag is also supplied with the section with water coil. It contains:
- n. 4 anti-vibration mounts
- n. 4 attachment brackets
- n. 8 M8 x 20 screws
- n. 4 notched washers diam. 8 mm.
positioning
• The section with water coil must be positioned in front of the machine flow vent.
The collector marked by the "WATER OUTLET" label must be at the side of the machine (1)
• Remove the side panel of the section with water coil, loosening the screw fasteners (2)
• Partially tighten the 4 M8 screws into the inserts present at the tops of the machine event (3)
• Hitch the section with water coil to the machine, passing the head of the projecting screws through the holes and
push the section down, in a way that the head of the screws is blocked in the upper part of the hole. Access the 4
screw fasteners from the side of the section and tighten them (4)
• Fix the side of the section again (5)
Ceiling fixture
• Fix the supplied brackets to the section using the 4 M8 screws to be
tightened in the relevant inserts (6)
• Fix four threaded M8 tie-rods to the ceiling in correspondence with
the brackets. Block the unit by tightening the fixing bolts (7)
1 2 3
4 5 6
7
Attention: the installation of the section with water coil leads to additional pressure drops
in the introduction circuit. These drops are stated in the table on page 9 (“Coil air side pressure drop”)
page 14
Heat Recovery Units Installation, Use and Maintenance Manual