18
6.3 VIEWING THE STATUS OF THE UNIT PARAMETERS (PARAMETER)
These pages display the current values for the unit's operating parameters. After
accessing the "Parameters" function, you can browse the various pages using the
buttons on the left and right sides of the window. The following table shows the
information available.
NOTE: all information contained in this menu is "read only".
Label
Meaning
T-outdoor
Indicates the external air temperature detected by the unit
T-suction
Indicates the temperature on the compressor inlet
T-discharge
Indicates the compressor delivery temperature
T-Defrost
Indicates the temperature for the defrosting cycle
T-water in PE
Indicates the temperature of the water entering the plate heat exchanger
T-water out PE
Indicates the temperature of the water leaving the plate heat exchanger
T-optional water sen.
Indicates the temperature of the water leaving the optional heater (paragraph "7.9 Setting an additional heater (Optional
E-heater) p. 21")
T-tank ctrl.
Indicates the temperature measured in the compatible Aermec accessory tank
T-economizer in
Indicates the temperature on the economiser inlet
T-economizer out
Indicates the temperature on the economiser outlet
T-floor debug
Indicates the set temperature for radiant floor debug (paragraph "7.12 Setting the pre-heating procedure for radiant panels
(Floor debug) p. 22")
Debug time
Indicates the set time for radiant floor debug (paragraph "7.12 Setting the pre-heating procedure for radiant panels (Floor
debug) p. 22")
T-gas pipe
Indicates the temperature detected on the gas side of the cooling circuit
T-liquid pipe
Indicates the temperature detected on the liquid side of the cooling circuit
T-auto mode
Indicates the current set-point temperature, calculated using the climatic curve (paragraph "4.7 Setting the automatic setting
compensation on the basis of external air (Weather depend) p. 10")
T-remote room
Indicates the room temperature detected by the probe (paragraph "7.10 Setting the installation of the remote room
temperature probe (Ambient sensor) p. 22")
Dis. pressure
Indicates the compressor delivery pressure value
6.4 VIEWING THE ACTIVE ERRORS ON THE UNIT (ERROR)
These pages display the current errors and alarms active on the unit. After accessing
the "Error" function, you can browse any pages using the buttons on the left and
right sides of the window;
Note:
1.
This function does not allow current errors to be reset; it only displays them;
2.
For more information about the error codes, refer to chapter "9 Alarm
codes p. 27";
3.
There may be several pages, depending on the number of errors (up to 5 errors
per page).
6.5 VIEWING THE ERROR LOG (ERROR LOG)
These pages display the alarm log for the unit. After accessing the "Error" function,
you can browse any pages using the buttons on the left and right sides of the win-
dow;
Note:
1.
There may be several pages, depending on the number of errors; the log lists
the last 20 errors;
2.
For more information about the error codes, refer to chapter "9 Alarm
codes p. 27";
6.6 VIEWING SOFTWARE INFORMATION (VERSION)
These pages display the version of the software installed on the unit.
