Aerian COSY1800, Operating Instructions Manual

Page: 10 / 50

No warm air is coming
from the heater.
1.The overheat protec on
device in the appliance has been
triggered.
2.The thermostat knob may be
adjusted at a too low posi on. 1. Turn all controls o ff , unplug the
appliance, and allow to cool for at
least 10 min before plugging back in
and restar ng.
2. Rotate the thermostat knob
clockwise to the “MAX” posi on.
The appliance turns
o
ff and will not turn
back on.
1. The overheat protec on
device in the appliance has been
triggered.
2. House circuit breaker has
been tripped. 1. Turn all controls o ff , unplug the
appliance, and allow to cool for at
least 10 min before plugging back in
and restar ng.
2. Reset house circuit breaker.
The appliance does
not turn on when the
switch is pushed to
“ON”. The overheat protec on device in
the appliance has been triggered. Turn all controls o ff , unplug the
appliance, and allow to cool for at
least 10 min before plugging back in
and restar ng.
Flame is dim or not
present. 1. Light bulb is burnt out.
2. “Flame wand” has come loose
from bracket.
3. “Flame wand” motor is not
func oning. 1. Inspect light bulb and replace if
necessary. (See the sec on Replacing
the light bulb of this manual.)
2. Please contact a professional
technician to do the following.
Remove screws holding back access
panel in place and remove back
access panel .Secure end of “
fl ame
wand” back into the support bracket.
EN7
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
SPECIFICATIONS
Ra ngs: 220-240V~ 50-60Hz
1800W