Aerial Aerocube VT2 Series, Instruction Manual

Page: 7 / 20

CONSTRUCTION
Page 5 of 15
3 Construction
Fig. 1: AERIAL water separator series VT2 - overview
1 On / Off switch 6 Appliance socket for compressor
2 Connection for compressor 7 Power cable
3
Control panel with full text
display
8
G¾“ threaded connector for
waste water
4 Tension lock 9 Holder for power cable
5 Water container and pump
Water separator VT2 ready for connection designed for screed insulation layer drying
in the vacuum mode, with compressor or soundbox VP2/VP3/VP6.
The connected compressor (soundbox VP2/VP3/VP6) draws the air/water taken in (e.g.
from the insulation layer) through the water separator. The water is collected in the
bottom part of the VT2. The integrated level controller switches the side channel
compressor off and the waste water pump on. The waste water pump pumps the water
out of the VT2 through the waste water hose.
When the water level in the VT2 drops below approx. 1 cm, the compressor switches on
again and operates up to the next pumping process.