TECHNICAL AND MAINTENANCE DOCUMENTATION
HAT
9
www.aereco.com
5. START-UP
The fans require periodical service twice a year which must include checking the general
condition and cleaning the impeller and the housing. Before operation, service or repair of
the device, it is necessary to make sure that
·
the employee performing the inspection has been trained and knows the safety rules,
·
the power supply is disconnected (circuits of all poles) and that it is not possible for
third parties to switch on the fan,
·
the fan impeller is no longer rotating.
·
The fan bearings do not require lubrication and should be replaced if faulty.
·
Do not use pressurised equipment (compressed air or pressurised water) to clean
the fans.
·
When cleaning, make sure that the weights balancing the impeller are in place and
the impeller is not deformed.
·
After cleaning, make sure that the fan works without any abnormal noises.
·
Check that the impeller is not jammed and that the motor protection is not loosened.
HAT fans are factory packed in appropriate cardboard boxes. It is recommended to leave
the fans in their original packaging during the whole transport to the place of installation.
During transport, the fans should not be thrown, knocked over or additionally weighted.
Prior to mounting, the fans should be stored in dry and well-ventilated spaces.
6. USE
7. TRANSPORT AND STORAGE
ATTENTION!!!
-
Service notifications should
be made via
the website
:
www.serwis.aereco.pl
-
Start-up must be documented
by an entry in the warranty
card.
ATTENTION!!!
-
Failure to carry out the
inspection will result in the
loss of warranty.
AERECO S.A. RESERVES THE RIGHT TO MAKE CHANGES TO THIS TECHNICAL
MANUAL WITHOUT NOTICE.
Summary of Contents for HAT-100-B
Page 2: ......
Page 10: ...NOTES ...
