14
It allows to save the setting of the #1 (prototype) installation in the internal memory of
the CTRL-DSP to be loaded afterwards in other units.
Press OK to enter.
Use
or
to choose the position where to save hte setting. Up to 8 differrent
settings can be saved.
Press OK to select.
Press OK to confirm.
Press ESC to go back to the previous menu.
It allows to load the saved setting on the next unit.
Press OK to enter.
Use
or
to choose the desiderd saved setting.
Press OK to select.
Press OK to confirm.
Press ESC to go back to the previous menu.
It allows to restore all the factory settings (
DEFAULT
).
Press OK to enter.
Press OK to confirm.
It allows to set the LCD contrast.
Press OK to enter.
Use
or
to increase or decrease the contrast.
Press OK to confirm.
It shows the internal functional parameters of the unit.
Press OK to enter.
Press ESC to go back to the previous menu.
Installer menu
11 Filter Alarm interval
12 Working Hours Counter
13 Save settings
14 Load settings
15 Restore Default Settings
Installer menu
11 Filter Alarm interval
12 Working Hours Counter
13 Save settings
14 Load settings
15 Restore Default Settings
Installer menu
11 Filter Alarm interval
12 Working Hours Counter
13 Save settings
14 Load settings
15 Restore Default Settings
Installer menu
16 Contrast
17 Debug page
Installer menu
16 Contrast
17 Debug page
To be selected only in case an F7 filter is installed at the supply air side (Fig. 7.a).
Press OK to enter.
Use
or
to choose “Not installed” or “Installed”.
Press OK to select.
The factory setting (DEFAULT) is “Not Installed”.
Installer menu
6 Heating Threshold
7 Dehumidification
8 Speed Setting
9 Airflow Balancing
10 F7 filter
Installer menu
11 Filter Alarm interval
12 Working Hours Counter
13 Save settings
14 Load settings
15 Restore Default Settings
It allows to set the Filter Alarm period: the system has a timer which activates the
“Filter” warning on the LCD at regular intervals.
Press OK to enter.
Use
or
to choose among 2-3-6 months or OFF.
Press OK to select.
The factory setting (DEFAULT) is 3 months if F7 filter is “Installed” or 6 months if F7
filter is “Not installed”
Installer menu
11 Filter Alarm interval
12 Working Hours Counter
13 Save settings
14 Load settings
15 Restore Default Settings
The system keeps trace of the actual working hours of the unit. This value cannot be
changed. Data is saved both on the motherboard and on the control panel CTRL-DSP,
to be safe in case of fault.
Press OK to enter.
Press OK or ESC to go back to the previous menu.
