>>
-
–
-
10
Remote Control Set-up
! Note:
Code matching is required even if the remote control may control the fan out of the box
!
Code match the transmitter with the receiver
Note:
receiver itself has
NO
DIP switch.
Speed Up 1-2-3-4-5-6
Down 6-5-4-3-2-1
To start the fan press speed button
To change speed of fan press or (indicated by a short buzzer sound)
LCD indicates maximal speed (max)
On/Off
Press the button to start or switch off the fan
Forward
For cooling effect and in combination with Air Condition System
(clockwise rotation)
Reverse
To support heating system to exchange temperature (counter clockwise rotation)
Light
Press the button to turn on or switch off the LED light (Light is optional)
Code match the Transmitter (Hand held) with the Receiver
1.
Set the code to be encoded by the Dip Switch of transmitter
2.
Switch on the main power to activate the receiver, indicated by (one beep)
3.
Within 3 minutes after the power is turned on (one beep), press the transmitter’s “ON/OFF”
key and do not release (min. 5 seconds) until receiver issues (four beep) short sounds which
indicates successful code match
4.
After successful code match, the fan automatically returns to the original speed as indicated
on LCD screen
5.
Press any transmitter button to check for proper functioning
6.
For code changes, repeat steps 1 to 5
The transmitter and receiver will memorise the code for future use (also if switched off).
Remote Control Code Setting
Set your Dip Switch to control individual
fan(s) (one per fan handset) and
only
power to one fan receiver per time
.
Chose same code setting for up to 8 fans
controlled by one handset within a 7m
(23’) radius with power to all fans.
Dip Switch
