Pairing is always required during setup.
Note:
“LEARN” switch on receiver.
7
STEP 6
Pairing the Remote Control
Controlling the Fan
1. Insert batteries
2. On Receiver: switch the “LEARN” switch to “ON”
3. Switch on the main power to activate the receiver, indicated
by (one beep)
4. Within 60 seconds after the power is turned on (one beep),
press the Fan “ON/OFF” button and do not release (min. 3
secs) until Fan receiver issues three “beeps” which indicates
successful pairing.
5. On Receiver: switch the “LEARN” switch to “OFF” (this will
lock the code with the remote)
6. Finish STEP 7, 8 & 9 before pressing ON/SPEED
button to check for proper functioning
7. To re-pair, repeat steps 2 to 5
NOTE: Power must be off for 10 seconds
minimum before repairing.
The Remote Control and Fan Receiver will
memorise the set code for future use even if
mains power is switched off.
LIGHT SWITCH: Select ON/OFF or DIMMING for the light function.
(Light will maintain last setting if turned off)
1. Fan ON/OFF
2. Fan Speed UP/DOWN
2a. Fan Speed indicator 1-6
3. Forward / Reverse
3a. Use Forward mode (clockwise) for cooling
3b. Use Reverse mode (anti-clockwise)
to circulate warm air
4. Light ON/OFF
4a. To DIM, press and HOLD light button
to cycle from bright to dark.
(LIGHT SWITCH at DIMMING position)
One Remote control can control up to 8 fans (within a 7m (23’) radius). On ALL receivers:
switch the “LEARN” switch to “ON”. Switch on the main power to activate ALL receivers at
the same time, indicated by one ‘beep’ Within 30 seconds, press and hold the ON/OFF
button on the remote control (min. 3 seconds) until fan receiver issues three ‘beeps’.
Pairing a Single Fan per remote control: LEARN MODE
!
1
4
3b
2
2a
Pairing Multiple Fans per Remote Control
3
3a
4a
LIGHT SWITCH
LIGHT DIMMING
LIGHT ON/OFF
