9
6. Technische Daten
Effects
Internal effect
Digital effect processor
1 Reverb with short predelay
2 Reverb with long predelay
3 Delay (320ms, repetitive)
4 Chorus
Parallel effect loop, see send and return
efx pan
Blends both internal and external effects
between channels 1 and 2, with reverse
direction of rotation for the external effects
Power amp
Construction
Monolithic IC with DMOS output
Output power
60 W / 4 ohms (THD = 1%)
Continuous output power is determined
by limiter, see limiter threshold.
General
Distortion
THD + N < 0.1% (6 W / 4 ohms),
measured at loudspeaker terminals
Noise
Residual noise (A-weighted SPL):
approx. 17 dB (A) / 1 m
See also inputs and outputs for noise data.
Analog signal
processing
Subsonic filter, adaptive peak limiter
Limiter
threshold
50 W / 4 ohms
Speaker system
8” (200 mm) dual cone full-range
speaker, bass reflex enclosure
Mains power
Mains voltage (depending on model):
100, 120, 220, 230, or 240 V~, 50–60 Hz
Power consumption: max. 120 W
Mains
fuse
Size: 5 x 20 mm
For 220, 230, 240 V models: T 1A L 250V
For 100, 120 V models: T 2A L 250V
Operating
0…35 °C
temperature range
Cabinet
12 mm (0.47”) birch plywood
Finish
Waterbased acrylic, black spatter finish
Dimensions and weight
Dimensions
260 mm (10.2“) high
205 mm (12.8“) wide
235 mm (9.25“) deep
Weight
6.5 kg (14.3 lbs)
Notes
Options configurable by internal jumpers (refer
modification to qualified personnel):
·
9 V phantom power for channel 1.
Caution: Phantom power may damage external
equipment. Read the notes in the operating
instructions.
·
Low-gain option (more headroom) for mic input
·
Deactivation of 48 V phantom power for mic input
DEFINITIONS
Rated conditions
·
Nominal input voltage at input under test
·
master fully clockwise
·
high / low and colour off
·
bass / middle / treble / pan centered
·
gain of unused inputs and efx level fully anticlockwise
·
gain of input under test adjusted to nominal output
voltage at line out. (This condition corresponds by design
to the rated output power.)
Nominal input voltage: Standard condition for specifications,
if not stated otherwise.
Minimum input voltage: Input voltage required for nominal
output with maximum gain and volume settings.
Maximum input voltage: Input voltage that does not cause
distortion more than rated THD+N, suitable control settings
provided.
Nominal output voltage or power refers to rated conditions.
THD + N: Total harmonic dist noise, input
voltage reduced by 10 dB after setting up rated
conditions.
Signal / noise ratio: Ratio of output voltage at rated
conditions to output noise voltage with input shorted.
Equivalent input noise voltage: Noise voltage at loudspeaker
terminals divided by gain of amplifier. Input shorted after
setting up rated conditions.
Residual noise: Output noise with minimal gain and volume
settings.
Adaptive limiter: Adaptive with respect to power supply.
Maintains constant headroom regardless of power supply
fluctuations.
General: Signal voltages are RMS values. Test signal sine 1 kHz
sine unless stated otherwise. Noise measured from 20 Hz to
20 kHz. Noise stated for a specific input implies that all other
inputs are not used. Sound pressure level (SPL) based on louds-
peaker specification by manufacturer.
Specifications and appearance subject to change without
notice.
TD20160511 (Compact 60/3)
