Please note:
The signal path is interrupted in the serial mode. If no acces-
sory unit is connected, the signal cannot find its way into the
power amplifier, and you will hear nothing. This is not a mal-
function but a misuse.
When used in the serial mode,
the pan control should be set as follows: As far as it will turn
left:
effect on channel 1, not on channel 2
middle:
effect 2 on channel 1 and channel
As far as it will turn
right:
effect 2 on channel 2, not on channel 1.
That is it – have fun!
AER GmbH und Co. KG.
D – 45665 Recklinghausen
Telephone: +49 (0)23 61–89 17 89 / -90
www.aer-amps.com
Copyright: AER, Recklinghausen
Telefax: +49 (0)2361 – 891791
AER assumes no liability for printing mistakes. Technical data is
subject to alteration after printing.
That allows you to:
Switch between the two stored effects (memory 1, 2)
Switch on/ off the effect loops 1 + 2
Effect 1 (internal) on/ off: brief tapping
Effect 2 (external) on/ off: longer tapping
Connect volume pedals or footswitches to sockets ctr ch 1 and
ctr ch 2 to VCA level the volume of each channel or mute it
(e.g. in tuner mode) without affecting the sound.
When using a dual footwitch or a stereo volume pedal, a
single stereo connection with ctrl ch1 is sufficient.
effect 2
In addition, a further stereo effect unit, called
effect 2, can be connected. The send socket
needs to be connected to the input of the
effect unit.
The
return
socket is stereo, and accepts both output-channels
of the effect unit.
An "insert” -cable might be required (see "Wiring-Diagram”).
The effect return and effect pan controls correspond to the
controls at the front (effect 1).
Please consider:
If you use a mono accessory unit, you would also use a mono
return-cable. The effect signal lies on the tip. The Acousticube
internally uses the left effect portion of effect 1 that also lies
on the tip.
Thus your mono accessory unit is linked with the acoustiCube,
but is only operative for the Acousticube. The signal is only
available at line (line out) and r–out when a special stereo-
cable is used. The mono-signal of the accessory unit should lie
exclusively on the "ring” (middle ring) of the stereo jack (the
effect only works on the right side, therefore not on the acou-
stiCube, only on the accessory box CX8). But if you connect
"tip” and "ring” the mono-effect will spread to both sides (left
and right), that is to the acoustiCube as well as to the stereo
extension CX8.
The ser/par-switch switches effect 2 from serial to parallel mo-
de, depending on whether the original signal is supposed to
pass through the effect completely (e.g. for EQ or compressor)
or whether it is separated.
acousti
Cube 3
C
-9-
