Make sure that the LED is breathing its white LED.
2.
Set your Z-Wave Controller into pairing mode.
3. Press the Z-Wave Button on your Range Extender and quickly release the button (should only be a quick
tap action on the button).
Range Extender 7 will quickly flash its white LED up to 30 seconds or until it is paired successfully. If
successfully paired, the LEDs light will become brighter.
If your repeater failed to pair, the LED will return to slow breathing LED. If it is this case, please return to
step 2.
4. If you pairing with S2 encryption/security, enter the first 5 digits of the DSK into your
controller/gateway/hub interface when requested.
The DSK is printed on the Range Extender 7 itself located right under the QR code.
General LED Status
There are a few LED indications that you will need to pay attention to for the Range Extender 7.
Unpaired from network.
Slow breathing white LED
While paired to an existing network.
The LED state is configurable, there are 2 states that you can choose, the LED will remain in a solid state as
off or on:
LED on.
LED off.
