30-09-2020 13
:
08
Pagina 2 van 5
http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZWA003
Safety Warning for Batteries
The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries of different charging level or different brands.
Installation
Open the cover
Insert your battery and close the cover
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be
added to an existing wireless network
to communicate wi
devices of this network. This process is called
Inclusion
.
Devices can also be removed from a network. This process is called
Exclusion
. Both processes are initiated by the primary controller of the Z-Wave netwo
controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.
Inclusion
1. Open the NanoMote
2. Insert the battery
3. Press the button on the NanoMote One twice
Exclusion
1. Press the button on the NanoMote One twice
Product Usage
LOW BATTERY ALARM FUNCTION
NanoMote Quad will send battery report to the lifeline group when button is triggered during the sleep mode. If the battery level of the NanoMote Quad is le
20%, the NanoMote Quad will send a low battery alarm to the main controller.
CHILD LOCK FUNCTION
Child Lock function. If enable the Child Lock function, the LED indicator will not be on when press down the button. To switch on/off the Child Lock function,
press and hold the button for 10 seconds, the LED indicator will be solid on in red. Then release the button, the LED indicator will be continuously stay in re
seconds. During this 2 seconds, please click the button once, the LED light will be blink fast in red for 2 seconds.
TESTING Z-WAVE NETWORK RANGE
Press and hold the button for 15 seconds, the LED light will be solid on in purple. Then release the button, the LED light will be stay in purple for 2 seconds,
2 seconds, please click the button once, it will start to test the Z-Wave network range and LED light will blink fast in purple. After finish the test, if the LED li
green, it refers to strong signal; if in blue, it refers to medium signal, and if in red, it refers to weak signal or no signal.
Tip: This function works only when NanoMote Quad has been included into a ZWave network.
